Debian templates

The Debian template is an officially supported template in Qubes OS. This page is about the standard (or “full”) Debian template. For the minimal version, please see the Minimal templates page. There is also a Qubes page on the Debian Wiki.

Installing

To install a specific Debian template that is not currently installed in your system, use the following command in dom0:

$ sudo qubes-dom0-update qubes-template-debian-XX

(Replace XX with the Debian version number of the template you wish to install.)

To reinstall a Debian template that is already installed in your system, see How to Reinstall a template.

After Installing

After installing a fresh Debian template, we recommend performing the following steps:

  1. Update the template.

  2. Switch any app qubes that are based on the old template to the new one.

  3. If desired, uninstall the old template.

Installing software

See How to Install Software.

Updating

For routine daily updates within a given release, see How to Update.

Upgrading

There are two ways to upgrade your template to a new Debian release:

Release-specific notes

This section contains notes about specific Debian releases.

Debian 12

If you want to use a Debian 12 template for salting Qubes, you must stop the salt-common and salt-ssh packages from being upgraded. Do this by marking these packages on hold before updating the template.

sudo apt-mark hold salt-common salt-ssh
sudo apt update
sudo apt upgrade

This is a known bug in Salt which affects version 3006-5.

Starting services

The Debian way (generally) is to start daemons if they are installed. This means that if you install (say) ssh-server in a template, all the qubes that use that template will run a ssh server when they start. (They will, naturally, all have the same server key.) This may not be what you want.

So be very careful when installing software in Templates - if the daemon spawns outbound connections then there is a serious security risk.

In general, a reasonable approach would be, (using ssh as example):

  • Install the ssh service.
  • systemctl stop ssh
  • systemctl disable ssh
  • systemctl mask ssh
  • Close down template

Now the ssh service will NOT start in qubes based on this template.

Where you DO want the service to run, put this in /rw/config/rc.local:

systemctl unmask ssh
systemctl start ssh

Don’t forget to make the file executable.

Unattended Upgrades

Some users have noticed that on upgrading to Stretch, the unattended-upgrade package is installed.

This package is pulled in as part of a Recommend chain, and can be purged.

The lesson is that you should carefully look at what is being installed to your system, particularly if you run dist-upgrade.

Package installation errors in Qubes 4.0

If some packages throw installation errors, see this guide.